Lighting Mockup

As stated long ago, I want to light the layout with the actual lighting solution so that I can eliminate variance in light from the colour selection problem and this requires the prerequisite infrastructure. I have happily arrived at that point! Next up is working out how to actually mount the chosen LED strips to the valance/pelmet (I previously referred to it as a pelmet but I am going with valance since it is the more familiar word).

Questions to be answered:

  • One “daylight” strip or a daylight and a warm white?
  • Is one strip bright enough?
  • Can the strip(s) be mounted parallel to the baseboard (facing straight down) or does it need to be angled?
  • Do I need something to shield the back edge to direct light down?

The internet is full of various opinions on these questions with no clear consensus. I thus set out to experiment and determine what works for me. I cut a 4′ long cardboard strip and stuck lengths of both types of strip (the excess not needed from 5m rolls for Comstock Roads less than 4m length). After some practice soldering wires to the pads on the strips, I had a working light.IMG_20200711_140748211

Actual experience was informative. It was immediately obvious that the addition of the warm white strip made the overall effect way too yellow for my taste. (1970’s summer smog is not what I want to remember!)

I am unconvinced that one daylight strip is enough but it is at least adequate. It also has the advantage of only needing the default power brick for a power supply. I have decided include space for a second strip but not delay things on its’ account.

The default straight down mounting seems to be close to enough. The spread of light is more than enough to shine well above the backdrop edge so no need to aim it further back.

Here is the test shot with just single LED strip, no room lights and a car on the front track.IMG_20200711_164101780

You can see in the first photo where I put a bend in the cardboard to simulate some sort of backside restriction of the light arc. The LED strips are bright and nobody looking at the layout from the back is going to appreciate looking in the direction of the strip so something needs to block that. As well, any illumination above the top of the backdrop is wasted and perhaps a distraction anyway.

Here is my makeshift back bend in action. I am not excited by the angled shadows on the tall side boards but I can live with that. If people are looking up there, I have lost their attention anyway. With room lights on, the shadow is also much less prominent.

IMG_20200711_164226274

After some sketching and pondering, I think I will go with a simple right angle back of appropriate length rather than fooling about with an angled piece. Ease of construction isn’t my usual motivator but perhaps I am undergoing character development!

One thought on “Lighting Mockup”

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: