I have three projects in motion at the moment where motion is defined as taking up a work surface.
- Beam Engine: the chemical removal of the broken tap experiment is a bust. I will have to make a new cylinder. New tap just acquired so I can proceed.
- RS-3 Proto:48 conversion: all over the workbench but I think I can make it work
- Lathe Drawers: because that wasn’t enough balls in the air I am taking advantage of the nice weather to turn a sheet of plywood into some drawers for my lathe stand so I can clear up the shelf pile of lathe stuff and stack of assorted cases under the lathe.
I should have the shelves knocked out this weekend if only because assembly takes up most of the good floor space in the shop.