I have previously mentioned some books on model related metal work by Simon Bolton and Kenneth C. Foran. My soldering and brass shaping skills are rudimentary at best and I did not feel comfortable plunging directly into rolling stock construction so I set out to find a simpler project. While walking past a construction site, I hit upon the answer, a roll off waste bin. These ubiquitous items of the modern era are locally sourced and constructed from metal sheet and structural shapes. Just like those in the metal rack at the hobby shop!
I cast about for a suitable example and discovered that most waste disposal companies provide overall dimensions for their bins as well as photos thereof. Just the thing for the modeler in need. Subject identified, I prepared a basic dimensioned drawing and set about acquiring the necessary brass square tube sizes and sheets.
I made good progress but there was an issue. My Hakko FX888 digital soldering iron is not quite up to the job of soldering a joint where one or both halves is a big sheet of brass aka a heat sink. Cold joints were the order of the day and I put things aside while I mail ordered a big 120 watt iron in hopes of solving that problem.
Today I dusted things off and had a go, big iron and all. The thing is a monster with a half inch tip on it. Not for detail work but boy howdy, does it heat things up. Maybe too much. I managed to avoid desoldering everything previously attached but that wouldn’t be hard to do. Perhaps a finer tip is in order if I can get one.
Anyway, here are the two competing irons, the Hakko
And the 120 watt Weller old school iron (not so old school as to involve fire but still)
And here is the project to date. Todays progress was putting the sides, end and bottom together.